DIY LG Washer Bearing Replacement: A Comprehensive Guide

As a homeowner, it's important to maintain your appliances to ensure their longevity and efficiency. Bearing replacement on LG washers is a common task that can be accomplished with the right tools and knowledge. This article will provide you with a comprehensive guide to bearing replacement on LG washers, covering the basics, step-by-step instructions, and tips to make the process easier.

What is a Bearing and Why Does it Need to be Replaced?

Bearings are essential components in LG washers that allow the drum to rotate smoothly during washing and spinning cycles. Over time, bearings can wear out due to friction, water damage, or heavy use. A worn-out bearing can cause your washer to make loud noises, vibrate excessively, or even fail to spin.

Bearing Type	Description
Ball Bearing	Uses small steel balls to reduce friction
Roller Bearing	Uses cylindrical rollers to distribute weight more evenly
Tapered Roller Bearing	Designed to handle heavier loads and can withstand misalignment

Step-by-Step Guide to Bearing Replacement on LG Washer

Tools Required:

Screwdriver

Wrench

Hammer

Bearing puller

New bearings

Sealant

Steps:

Unplug the Washer and Shut Off Water Supply: Safety first! Unplug the washer and shut off the water supply to prevent any accidents.

Disassemble the Washer: Remove the screws holding the top and back panels of the washer and lift them off. Locate the drum and disconnect the hoses and wires attached to it.

Remove the Drum: Carefully lift the drum out of the washer tub and set it aside.

Remove the Old Bearings: Use a bearing puller to carefully remove the old bearings from the drum shaft. Clean the shaft thoroughly to remove any debris.

Install the New Bearings: Apply sealant to the new bearings and carefully press them onto the drum shaft. Ensure they are properly aligned and seated.

Reassemble the Washer: Place the drum back into the washer tub, reconnect the hoses and wires, and reassemble the panels.

Test the Washer: Plug the washer back in, turn on the water supply, and run a spin cycle to ensure the bearings are working properly.

Common Mistakes to Avoid

Using Incorrect Bearings: Ensure you use the correct size and type of bearings for your LG washer model.

Damaging the Shaft: Be careful not to damage the drum shaft while removing or installing bearings.

Ignoring Water Leaks: Address any water leaks immediately to prevent further damage.

Insufficient Sealant: Apply sealant generously to the new bearings to prevent water ingress.

Incomplete Disassembly: Ensure you completely disassemble the washer to access the drum and bearings properly.

Success Stories

"I replaced the bearings on my LG washer myself and saved hundreds of dollars compared to calling a repairman. The instructions in this article were clear and helpful." - Sarah J.

"My washer was making a horrible noise, but after replacing the bearings, it's like new again. I'm so glad I tackled this project myself." - John M.

"I appreciate the detailed explanation of the bearing replacement process. It gave me the confidence to do it myself and I'm thrilled with the results." - Emily K.

DIY LG Washer Bearing Replacement: A Comprehensive Guide